Century Hawk Pro Instruction Manual download pdf (Page 16)

From parts bag 3, slide the Fuel Tank into position and assemble the Lower Frames with

four 3x16mm Self Tapping Screws into the gyro plate ( remember to build the sideframes on a flat surface

while tightening the screws ).

STEP 19

Gyro Tray

[HI3112]

Fuel Tank

[HI3138A]

Note: The fuel

tank opening

should be

installed with

the fittings on

the right side to

align close to

the carburetor.

Lower Side Frames

[HI3112] x 2

M3x16 Self

Tapping

Screws x 4

STEP 18-19 Fuel Tank & Lower Frames

From parts bag 3, insert the two pieces of aluminum tubing through the large cap, rubber

stopper and small cap, bend the long aluminum tube upwards ( make sure the tube comes to the top of the

fuel tank ) and attach the short piece of fuel line and clunk to the short straight piece of tubing. Test fit the

assembly into the Fuel Tank and make sure that the clunk reaches the end but moves freely and the vent tube

is near the top of the tank but does not touch. Install the included tie wrap around the outside of the rubber

cap. Finally tighten the long self tapping screw to seal the tank.

STEP 18

Vent Tube - bent

and ends near the

top of the tank.

Note: The fuel tank opening is off-center and should

be installed upwards to align close to the carburetor.

Large Cap

Small Cap

Rubber

Stopper

50mm Fuel line inside

tank with Clunk

Pickup tube -

straight

Fuel Tank [HI3138]

M2.5 x 18 Self

Tapping Screw

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Comments to this Manuals

No comments

Century Hawk Pro Instruction Manual Page 16

Comments to this Manuals

Related products and manuals for Toys & accessories Century Hawk Pro