Century Hawk Pro Instruction Manual download pdf (Page 8)

STEP 5

STEP 5-6 Flybar, Paddles & Washout

Attach two Short Balls to the Washout

Mixing Arms ( Note, attach from the flat

side of the arm). Secure the semi-as-

sembled mixing arms onto the Washout

Hub using one slide tube inserted from the

flat side and secured using one 3x16mm

Socket Cap Screw and 3x7mm Flat Washer per

arm. Press the radius link on to the inner balls on

the Swashplate.

STEP 6

Semi-Assembled

Align each paddle 'A' to be parallel with the flybar

control arms 'B'. This is made very simple with the optional pitch and paddle gauge CN2026

M3x5SS Set Screw x 2

(small hex key)

M3x3SS Set Screw x 2

(small hex key)

Radius Link

& M2x12 Pin

[HI3152A]

M3x16 Socket

Cap Screw x 2

Flybar [HW3173]

* packed with

tailboom

Flybar Paddles

& Weights

[HI3179] x 2

Flybar Control Arm x 2

Steel Ball x 2

M2x10PH x 2

[HI3176]

From parts bag 1, slide and center the Flybar through the seesaw arm assembly. Install one

Steel ball onto each flybar control arm with one 2mm screw, slide the Spacer, Flybar Control Arm on the

flybar. Loosely tighten the control arms. Using a ruler, check the distance between the end of the flybar and

the control arm and adjust until the lengths are the same and there is no free play between the control arms

and the rotor head. Remove one set screw at a time, apply threadlock and tighten in place. Slide the Flybar

Weight (Tip: the flat end of the weight faces the paddle) and thread on the Flybar Paddle until all the threads

are covered onto the flybar and align the paddles parallel. Again using the ruler, rotate one paddle or the

other to get equal distances, remember leading edge of the paddles turn clockwise. Using two 3x3mm Set

Screws secure the weights using threadlock.

Swashplate

Assembly

[HI3146A]

M3x7 Flat

Washer x 2

Medium

Black Ball

x 2

Washout Hub Assembly

[HI3152B]

Spacer M3x6

[HI3167D]

Slide

Tube x 2

A=B=A

Leading Edge

For balancing of

rotor head see Final

Adjustments

Clockwise

Rotation

Optional Head

Button

CN2215

Medium Black Ball x 3

Medium

Silver Ball

x 2

Short Silver

Ball x 2

Starting with the inside race, apply threadlock

and attach two short silver balls directly across

from each other, similarly attach two medium

silver balls to the remaining holes. Attach the

three medium black balls to the outside race.

The rear location is not used.

Oilite

bushing

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Comments to this Manuals

No comments

Century Hawk Pro Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Toys & accessories Century Hawk Pro