Century Hawk Pro Instruction Manual download pdf (Page 24)

STEP 33

From Bag 7, insert three tail drive shaft Guides on to the Brass Tail Drive Housing, found in

the bottom of the box (Note that one guide has a larger center hole than the others, slide

this one to the center of the brass tube ), add the remaining two onto the ends. Glue the

guides into position using Zap Ca on the brass tube. Insert the rod guide assembly into the

tailboom from the end with the 2 holes and position the

assembly centered in the tailboom ( gentle tapping with a

wooden dowel will easy the

insertion of the guides ).

Slide the three tail

pushrod guides onto

the tailboom engaging

tail pushrod. Thread

the pushrod connector

found in bag #4

onto the long pushrod,

the short pushrod will

be attached in Step 36.

STEP 33-34 Tail Guide & Tail Gearbox

20mm Tail Drive

Shaft Set [HW3063]

Put a flat spot on the the

round end of the Tail Drive

Shaft.

STEP 34

The Tail Drive Shaft has one end flattened

to engage into the main mechanics the

other end needs to have a flat spot 20mm

long filed on the round end of the shaft for

the two 4x4mm Set Screws in the tail rotor

input shaft. Thoroughly grease the tail

drive shaft and insert the newly filed end

into the tailboom end with the slots into

the drive shaft housing assembly (ensure

the end with the new flat spot exits the

tailboom end with the round holes ) and

degrease both ends of the shaft.

Tail Pitch Control

Rod Set

[HW3064C]

Tail Pushrod Guides

[HI3106A] x 3

Tail Drive Shaft Set

[HW3063]

Tail Boom

[HW3062]

Drive

Housing

( brass )

Drive Housing End

Guides x 2

Make sure the brass tubing is glued to the internal guides for the tail boom. Also, after

radio set up is complete glue the pushrod guides using a single drop of Zap Ca. One drop

will stop the pushrod from binding and still be able to remove them later.

Drive Housing Center

Guide

A flat file is the ideal tool for the job, alternately careful

use of a Dremel Moto Tool will work. It is important

that the flat be at least 1/4 of the diameter but no more

than 1/3 to avoid weakening the material.

File

Tail Drive Shaft

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 47 48

Comments to this Manuals

No comments

Century Hawk Pro Instruction Manual Page 24

Comments to this Manuals

Related products and manuals for Toys & accessories Century Hawk Pro